“When To Set The Hook”
(By: “The Bass Coach” – Roger Lee Brown)
How many times have you made a cast, reeled in your slack
line, and then all of a sudden you feel a bump, then BAM!
You try to set your hook but you miss the fish? Sound
familiar? Trust me; this happens to anglers all the time. I
can’t tell you how many times this occurs, especially while
observing my 3-day students and charter clients. Most of
them just can’t figure out why they keep missing fish when
they’re getting the strikes. Don’t feel bad if this sounds
like you, but I was also an angler that did exactly the same
thing for many years, in fact I was probably the worst at
pre setting a hook.
Setting the hook to early and missing fish don’t just happen
when fishing plastics on the bottom either. How many times
have you thrown a top water lure, then all of a sudden a
fish jumps on it and you JERK THE ROD! Just to miss the fish
again )-: hey, it happens all the time, especially on the
surface because it’s visual and probably the most exciting
way to fish for bass.
There are certain times when using different baits that you
want to set the hook immediately, and then on the other side
of the coin, there are certain times when you don’t want to
set the hook too quickly. In this article I will try to help
you understand a little more on the hook setting techniques
when using a variety of different baits.
Since top water fishing is the most exciting to most anglers
I will start with this type of fishing. One of my favorite
top water baits happens to be a Zara Spook. This bait is
probably (in my own opinion) one of the best “big bass”
baits that has ever been made. Problem: Unfortunately, the
only problem that I use to have with this bait is that I
would make a cast, watch it hit the water, then as soon as
it hit the water, immediately a fish would jump all over the
bait (before I even had a chance to start working it) and
seeing this happen I would immediately SET THE HOOK. Wow, I
can’t even try to tell how many fish I would loose by doing
this.
Remedy: Now, after several years later and hundreds of fish
missed by doing this I finally realized what I was doing
wrong. I was just too impatient and way to quick on the draw
when it came to setting the hook. I found that if you let
the fish take the bait and wait until you feel the pressure
of the fish before setting the hook you won’t loose a
fraction of the fish that you would miss otherwise. This
technique will apply to most all top water baits including;
poppers, prop baits, floating worms, jerk baits (hard and
soft), and the best of all of course, the Zara Spook. Now,
there is an exception to this rule if using certain baits
such as a buzz bait, sometimes frogs (while swimming), or
any action baits that you normally would work with a steady
motion you would set the hook quickly.
Next, we will cover the “in-between” (sub surface, but not
bottom) types of baits like the spinner bait, crank bait,
swimming plastics, and action baits.
First, let’s cover a crankbait. I have missed a good many
fish in the past while fishing a crankbait because I wanted
to set the hook to quickly (nothing wrong with that?), but
what I didn’t realize was that I wasn’t using the right tool
for the application. What I mean when mentioning the right
tool is that, I was using a rod that was to stiff, and when
I would try to set the hook I would usually miss the fish
because I didn’t have enough flex in my rod causing the bait
to break loose. You have to remember that most (not all) but
most crank baits have little treble hooks, and these little
treble hooks don’t allow a lot of penetration. So after
losing many fish over the years fishing crank baits I
finally thought to myself “DUH! Use a more flexible rod” so
I decided to get myself a very flexible rod for fishing a
crankbait with them little treble hooks on them (they do
make rods, especially for crank baits you know) and the
problem was solved.
Spinnerbaits are a story of their own. When fishing a
spinnerbait, keep in mind that it (normally) has only one
hook, and usually the hook is a big one. This means that
when fishing with a spinnerbait and using the “Chunk and
Wind” (or cast and retrieve) technique, when you feel a fish
hit the bait you need to SET THE HOOK! Quickly to penetrate
the hook into the fish for a good hook set. The best rod for
this type of application would be a medium heavy action with
some backbone. When using lighter action rods with single
hook baits the stronger set the better because the lighter
actions have much more flexibility and you need to penetrate
the hook as best as you can.. Now, most anglers prefer the
“Chunk & Wind” technique when using a spinner bait, but what
they don’t know is that a spinner bait can be worked at
least six different ways (very successfully) than just the
“Chunk & Wind” technique. A couple of these techniques
really don’t require a very quick set, but again that’s
another story.
When swimming plastic baits and using action baits with
single hooks, again, use a stiffer type of rod and set as
soon as you feel a strike. Action baits along with spinner
baits and swimming plastics are all quick reaction bites and
you usually won’t get another chance to set once a fish
grabs it.
Let’s move on to some of the bottom fishing baits. Plastic
worms, crawls, centipedes, just to name a few, are normally
fished with single hooks either Texas rigged, Carolina
rigged, Mo-Jo rigged, Mo-Wak rigged (which happens to be my
own technique I came up with), the Drop Shot rig and the
Wacky rig. This means once again that you may want a stiffer
type of rod and a good hook set because of using the single
hook. The best way I learned to successfully set the hook
using some of these baits is to let the fish pull a little
pressure on your line before setting the hook. This
technique is where most of my former students and charter
clients have had the worst time catching fish because they
had the attendancy to set very quickly as soon as they felt
a bite. After teaching them to reel in the slack and lifting
the rod tip just putting enough pressure to feel a fish, and
then setting the hook, most of them have been much more
consistent and successful at catching instead of missing the
fish. One very important thing I must mention is that when
lifting your rod tip for the feel of the fish, NEVER! EVER!
Tip the rod down and back up when setting the hook. This
causes a quick slack in your line and more times than not
you will loose the fish by doing that.
That’s enough for now, and I sure hope that this helps many
anglers who have the habit of doing what I used to when
setting the hooks. The right way, the wrong way, your way,
which’s to say? All I know is that it has made a big
difference to me as well as many anglers who had the same
problem as me in the past, and now we’re all happy campers!
If you feel you may wish to learn more about bass fishing
with my 3-day bass fishing school, or just want to charter a
day on the water, please feel free to call me at (518)
597-4240 or go to my website at www.basscoachfishing.com or
just drop me a email at rlbrown@capital.net Until next time,
take care & God bless! “Always”
“The Bass Coach” – Roger Lee